Skip to main content (Press Enter)
Helcim Logo
Click here if you return to contents

Installing & Removing the Battery

The information in this article pertains to merchants who have signed up for Helcim from June 1, 2020, onward. If you are using Helcim's Legacy system, please click here.

Installing or replacing the Helcim Card Reader battery is easy to do.

Simply follow these steps:

  • Start by positioning the Card Reader face down, and removing the rear battery cover.
  • Next, push the small white battery connector on the battery into the vacant port in the bottom left side of the battery compartment. A soft click will confirm the battery has been properly installed.
  • Now slide the battery door back onto your Card Reader.

Related Articles

Getting Started with the Helcim Card Reader
Unboxing Your Helcim Equipment
Using the Countertop Stand
Charging the Helcim Card Reader
Adjusting Screen Brightness

Was this article helpful?

Feedback submitted - Thank you!

If you need immediate assistance please contact our Merchant Experience Specialists here